The substrate has to be dry and at room temperature. If necessary, pre-heat. Clean thoroughly area to be repaired with the Cleaner
and allow to dry for approx. 30 seconds.
Apply Liquid Transparent to the area to be treated. Put on the Plastic Film and press on slightly. Do not press into the damage!
Put the PowerLight onto the damage and harden material approx. 30 seconds per cm². The PowerLight switches off automatically after 30
seconds.
Make short and quick movements with the Planer to strip off excess material. With marble we recommend to use the Cuttlebone.
Now use the Micro Sanding Paper 2400/3200/ 4000 with water (avoid development of creases when stretching Sanding Paper over the Felt Pad) to ensure the area is perfectly level.
Apply Polishing Paste and polish with the felt side of the Felt Pad. Alternatively it can be worked mechanically with the felt wheel.
If the desired gloss sheen has not yet been achieved, polish again.
Note:
When the lamp is put on, due to the lamp shade the light has exactly the correct distance to the damage (approx. 8 mm). You also can take off the shade while working on an area diffi cult to access. However, in this case, take care of the distance to be 8 mm to make the material cure properly. If during levelling fi lling material comes out, simply repeat the process.
